Attaching the T4000 Installation Handle
Installing the T4000 Chassis in a Rack or Cabinet Using a Mechanical Lift
Copyright © 2018, Juniper Networks, Inc.
Figure 36: Removing a DC Power Supply
To assist you with the installation of the router, attach the installation handle over the
power supply slots of the chassis. To attach the installation handle:
Place the installation handle over the location of the lower power supply.
1.
Tighten the captive screws of the handle into the holes previously occupied by the
2.
captive screws of the power supply (see
Figure 37: Attaching the Installation Handle
Because of the router's size and weight—up to 663.6 lb (301.0 kg) depending on
configuration—we strongly recommend that you install the router using a lift.
Chapter 18: Installing the Router into a Rack With a Mechanical Lift
Figure 37 on page
141).
141