Advertisement
Related
Documentation
Connecting an OCX1100 Switch to a Management Console by Using the Mini-USB
Type-B Console Port
Copyright © 2017, Juniper Networks, Inc.
To connect the device to a management console (see
Figure 32 on page
87):
Connect one end of the Ethernet cable to the console port (labeled
1.
or
CON1
) on the device.
Connect the other end of the Ethernet cable to the console server (see
2.
Figure 31 on page
87) or management console (see
Figure 31: Connecting a Device to a Management Console Through a
Console Server
CON
To Console
port
Figure 32: Connecting a Device Directly to a Management Console
Connecting a Device to a Network for Out-of-Band Management on page 85
You can configure and manage OCX1100 switches by using the RJ-45 console port or the
Mini-USB Type-B console port. However, the console input will be active only on one
port at a time—only one port will be set active at a time.
By default, the RJ-45 port is set as an active console port and the Mini-USB Type-B port
is the passive console port. For information about configuring the console port type, see
Configuring the Console Port Type (CLI Procedure).
If your laptop or PC does not have a DB-9 male connector pin or RJ-45 connector pin,
you can connect your laptop or PC directly to an OCX1100 switch by using a mini-USB
cable that has a Standard-A USB connector on one end and a Mini-USB Type-B (5 pin)
connector on the other end.
This section describes the process of connecting an OCX1100 switch to the management
console by using the Mini-USB Type-B console port.
Chapter 12: Connecting the Switch to the Network
Figure 31 on page 87
Figure 32 on page
Console server
and
,
,
CON
CONSOLE
87).
PC
87
Advertisement
Chapters
