Figure 53: Connecting An Ex Series Switch To A Management Console Through - Juniper EX2200 Series Hardware Manual

Complete Hardware Guide for EX2200 Ethernet Switches
116
To connect the device to a management console (see
54 on page 117):
Connect one end of the Ethernet cable into the console port (labeled
1.
CONSOLE ) on the device.
For the location of the
CON/CONSOLE
See "EX2200 Switches Hardware Overview" on page
See Rear Panel of an EX3200 Switch.
See Rear Panel of an EX3300 Switch.
See Rear Panel of an EX4200 Switch.
See Front Panel of an EX4500 Switch.
See Switch Fabric and Routing Engine (SRE) Module in an EX6200 Switch.
See Switch Fabric and Routing Engine (SRE) Module in an EX8208 Switch.
See Routing Engine (RE) Module in an EX8216 Switch.
See Front Panel of an XRE200 External Routing Engine.
Connect the other end of the Ethernet cable into the console server (see
2.
page 116) or management console (see
To configure the device from the management console, see
an EX Series Switch (CLI Procedure)" on page 129
Series Switch (J-Web Procedure)" on page
NOTE: EX2200-24T-DC switches, EX2200-C switches, EX3300 switches,
and EX6200 switches do not support switch connection and configuration
through the J-Web interface.
Figure 53: Connecting an EX Series Switch to a Management Console
Through a Console Server
To Console port
(on the switch)
port on different devices:
Figure 54 on page
or "Connecting and Configuring an EX
131.
Console server
Figure 53 on page 116 and
or
CON
3.
Figure 53 on
117).
"Connecting and Configuring
PC
Copyright © 2011, Juniper Networks, Inc.
Figure