Template Add/Edit; Logo Template - ZyXEL Communications Vantage Report User Manual

12.6 Template Add/Edit

Use this screen to customize a scheduled report template for a particular ZyXEL
Device.
To access this screen, click Add in the Report > Schedule Report > Configure
Template screen.
Figure 240 Report > Schedule Report > Configure Template > Add
Each field is described in the following table.
Table 224 Report > Schedule Report > Configure Template > Add
LABEL
Name
Device Type
Note
Report List
Apply
Reset
Cancel

12.7 Logo Template

Use this screen to see the list of existing logo templates.
Vantage Report User's Guide
DESCRIPTION
Enter a name to identify the template inside Vantage Report.
Numbers (0-9), letters (a-zA-Z), periods (.) and the underscore (_)
are allowed. Spaces are not allowed. The name must start with a
number or letter. Use up to 28 characters.
Select the ZyXEL Device you would like to associate with the
scheduled report template.
Write a short description to identity the scheduled report template.
Select which report(s) you want to generate and send in the e-mail
message. For some reports, you can select additional options. All the
bandwidth reports use the same direction setting.
Use the Select All check box at the bottom to select every report.
Refer to Figure 236 on page 512
Click this to save your settings and close the screen.
Click this to change the settings in this screen to the last-saved
values.
Click this to close the screen without saving any changes.
Chapter 12 Schedule Report
for the full view of Report List.
523