Modifying Ip Settings For A Bri Card; Removing A Bri Digital Line Card - 3Com NBX 100 Administrator's Manual

Modifying IP Settings
for a BRI Card
Removing a BRI
Digital Line Card
You can modify the IP settings for a Digital Line Card to meet changing
requirements.
The card must be on the same subnetwork as the Call Processor to
modify IP settings.
To modify the IP settings of a BRI Digital Line Card:
1 On the Digital Line Cards tab, from the Select Device Type drop-down list,
select T1/ISDN Board List.
2 Click Apply.
3 Select the BRI card for which you want to change the IP settings.
4 Click IP Settings.
If there is no IP Settings button in the dialog box, you have not yet
installed the IP licenses. You must install them before you can proceed.
5 To assign IP addresses, enter the first address in the First IP Address field.
The system sequentially adds the remaining addresses.
To assign IP addresses one at a time:
1 In the Digital Line Card IP Settings dialog box, click Assign Addresses
Individually.
2 Enter the desired IP addresses for the channels.
You must have IP licenses installed before you can enter addresses.
3 Enter the mask number appropriate for your site in the Common Subnet
Mask field.
4 Enter IP address for the Common Default Gateway.
5 Click Apply.
6 Click OK.
7 In the Digital Line Card IP Settings dialog box dialog box, click OK.
You can remove a Digital Line Card at any time.
CAUTION: Removing a Digital Line Card may affect your Dial Plan.
Configuring and Managing BRI-ST Digital Line Cards 225