Installing The Multi Direct Print Application - Ricoh AP204 Operator's Manual

If the address has been configured properly, the following message ap-
pears.
Reply from 192.168.15.16 : bytes=32 time<10ms TTL=32
If the address has been configured incorrectly, the following message ap-
pears.
Request timed out.
Configuring a Windows NT Computer
Follow these steps to configure a Windows NT to use the TCP/IP protocol.
A
Double-click the [Network] icon of [Control Panel], and confirm that "TCP/IP
Protocol" is in the [Network protocols] box of the [Protocols] tab.
Note
If the TCP/IP protocol is not installed, click [Add] in the [Protocols] tab, and
install it. For more information, refer to the Windows NT 4.0 online help.
B
Configure the TCP/IP protocols with the appropriate IP address, subnet
mask and other settings.
Confirm with the network administrator that the settings are correct.
C
Click the [Services] tab, and confirm that the "Microsoft TCP/IP Printing" is
installed.
If "Microsoft TCP/IP Printing" is not installed, click [Add] in the [ Services ]
tab, and install it. For additional help in installing and configuring network
services, refer to the Windows NT 4.0 online help.

Installing the Multi Direct Print Application

Follow these instructions to install Multi Direct Print.
Preparation
You must restart the computer after installing Multi Direct Print. Be sure to
close all applications before beginning the installation process.
Note
You must install Multi Direct Print and the appropriate printer driver in order
to print. To be able to browse the printer via the network, PRINTER MAN-
AGER FOR CLIENT needs to be installed.
To install this software you must be logged on as a member of the Adminis-
trators group.
A
Insert the CD-ROM that comes with the printer into your computer's CD-
ROM drive.
B
Open [Control Panel], and double click the [Add/Remove Programs] icon.
Preparing for a Network Connection
2
15