Ricoh AP204 Operator's Manual page 45

Setting Up the Printer for Network with the Operation Panel
8 Check if the pointer (U U U U U ) is at the rightmost digit, press { { { { { Enter} } } } } to register
the IP address you specified.
F
If you use TCP/IP, you should assign "33. Subnet Mask", "34. Gateway Add",
"35. Access CTL" and "36. Access Mask" using the same procedure for speci-
fying the IP address.
G
If you use TCP/IP, you should make settings for "37 Net Boot". You can
select how to assign the printer's address using the computer. Select one of
items on the table below.
Menu item on
3
the panel display
ARP+PING
ARP & RARP
ARP & BOOTP
ARP & RARP & BOOT
None (Default)
RARP+TFTP
BOOTP
RARP & BOOTP
DHCP
Note
Select "None", if you want to specify the address using the printer's opera-
tion panel.
You should set up your server, if you want to use "RARP+TFTP", "BOOTP",
or "DHCP".
1 Press {U} {T}
<System Menu>
2 Press { { { { { Enter} } } } } .
The current setting appears on the panel display.
<Net Boot>
*ARP+PING
3 Press {U} {T} until the method you want to use appears.
4 Press { { { { { Enter} } } } } .
26
ARP+PING RARP+TFTP
{U} {T} {U} {T} {U} {T} until the following message appears. {U} {T}
U
37.Net Boot
U
T
Available method
T
BOOTP DHCP