Installing The Ieee 1284 Parallel Type204 - Ricoh AP204 Operator's Manual

Installing the IEEE 1284 Parallel Type204

Note
The parallel interface board can be
attached to either the front or the
back side of the printer board. This
procedure is for attaching to the
front side.
You cannot install two parallel in-
terface boards at a time.
A
Check the contents of the box for
the following items.
• Parallel interface board
• Installation Guide
B
Turn off the printer's power switch
and remove all cables and cords
from the printer.
C
Remove both screws and remove
the printer board from the printer
as shown in the illustration.
Note
A coin can be used to remove the
screws.
Installing the IEEE 1284 Parallel Type 204
D
Remove both screws and the metal
plate from the printer board.
E
Insert the IEEE 1284 Parallel Type
204 board into the slot and fasten
it with both screws that were re-
moved in step D D D D D , as shown in the
illustration.
TPOP130E
2
TPOP170E
TPOP180E
15