Ricoh AP204 Operator's Manual page 182

E
F
Select the name of the Network Interface Board which is to be configured
by clicking it, and click [Next >].
Note
If you don't know which Network Interface Board you are configuring,
print the Configuration Page using the printer's operation panel, and select
the MAC address that is on the page.
G
Confirm that the MAC and IPX addresses are correct, and click [Finish].
[NIB Setup Tool] window appears.
H
Click [Configure].
The property sheet appears.
I
Click the [NetWare] tab, and make the following settings.
A In the [Print Server Name] box, input the name of the print server.
B In the [File Server Name] box, input the name of the file server in which a
print server is to be created.
Clicking [Browse], you can select a file server among those listed in the
Browse dialog.
C In the [NDS Context] box, input the context in which the print server is to
be created.
Clicking [Browse], you can select a context among those listed in the
Browse dialog.
Note
Object names must be input from a lower level and divided by a period.
For example, if you want to create a file server into NETWORK under
DS, input "NETWORK. DS".
D In the [Print server Operation mode] group, click [As Remote Printer].
E In the [Remote Printer No.] box, input the number of the printer.
Important
Use the same number as that of the printer to be created in the print
server.
F
G Click [OK] to close the property sheet.
H After the message appears to confirm the reboot, click [Yes].
J
In the [NIB] menu, click [Exit] to exit the NIB Setup Tool.
K
From Windows, run NWadmin.
NetWare 4.x Configuration
3
39