Installing The Network Interface Board Type204 - Ricoh AP204 Operator's Manual

Installing the Network Interface Board
Type204
Note
Use a shielded network interface
cable.
The network interface board can be
attached to either the front or the
back side of the printer board. This
procedure is for attaching to the
front side.
You cannot install two network in-
terface boards at a time.
A
Check the contents of the box for
the following items.
• Network interface board
• Ferrite core
• Installation Guide
B
Turn off the printer's power switch
and remove all cables and cords
from the printer.
C
Remove both screws and remove
the printer board from the printer
as shown in the illustration.
Note
A coin can be used to remove the
screws.
Installing the Network Interface Board Type 204
D
Remove both screws and the metal
plate from the printer board.
E
Insert the network interface board
into the slot and fasten it with both
screws that were removed in step
D D D D D , as shown in the illustration.
TPOP130E
2
TPOP170E
TPOP180E
13