Ricoh AP204 Operator's Manual page 289

Appendix
OS
Win/Mac
4
Note
If you cannot solve the problem by taking the above actions, contact your
sales or service representative.
48
Status
The following message
is printed when there is
not enough memory in
the printer to perform
printing.
"There is not enough
memory in your print-
er to print this page.
Change the resolution
to 300 dpi in the printer
driver and try again.
For details, please refer
to the troubleshooting
section in your manu-
al."
Possible Causes and Solutions
An error message is frequently printed.
Increase memory.
Install an optional memory unit (SIMM).
Turn on "Image Memory".
Turning on the "Image Memory" can cause
printing to take a long time. See the print-
er's "Operating Instructions" that comes
with your printer for details on the "Image
Memory".
An error message is occasionally printed.
Increase memory.
Install an optional memory unit (SIMM).
Reduce the resolution.
• Windows 95/98
On the [Graphic] tab, change the resolu-
tion setting to [300 dpi].
ics] Tab"
• Windows NT4.0
On the [Advanced] tab, change the [Reso-
lution] setting to [300 dpi].
vanced] Tab"
• Macintosh
LaserWriter 8.3x or earlier
On the [Print Options] dialog, change the
[Resolution] setting to [300 dpi].
"LaserWriter 8.3x or Earlier"
LaserWriter 8.4x or later
In the [Printer Specific Options] of the
[Print] dialog, change the [Resolution] set-
ting to [300 dpi].
P.16 " [Graph-
P.26 " [Ad-
P.39