Rps2 Menu Table - Ricoh AP204 Operator's Manual

Appendix
Parallel IF 2
Use this setting to use a second parallel interface by installing the optional
parallel interface board. You can specify the timing of the second parallel in-
terface. When "System Default" is selected, the setting in the "System Menu"
is used.
Important
Do not use "ACK Outside" setting.

RPS2 Menu Table

Item
1. Color Mode
4
2. Resolution
3. Color Set (Color
Setting)
4. Color Profile
5. Toner Saving
6. Dithering
7. Paper Type
A. Auto Tray SW
B. Job Timeout
C. I/O Timeout
D. Feed Timeout
E. Print Errors
F. KTalk Mode
G. Parallel IF1
H. Parallel IF2
*1
The setting is not effective.
*2
Available only when the optional parallel interface board is installed.
Note
Italic settings are the default settings.
54
Black & Color
White
300 dpi 600dpi
Off Bright
Photo- Presenta-
graph tion
Off On
Photo- Text
graphic
Plain Paper OHP
Off On
0 (Off) 0 – 999 seconds in 1 second step
300 sec- 0 (Off)
onds
60 seconds 0 (Off)
Off On
*1 7.5Compat 7.1Compat
ACK In- ACK Out-
side side
*2 ACK In- ACK Out-
side side
Available settings
Super Fine
Bright
Solid Color
Thick Pa-
per
0 – 999 seconds in 1 second step
0 – 999 seconds in 1 second step
System De-
fault
System De-
fault
Super Fine