Ricoh AP204 Operator's Manual page 230

Supported Systems
Windows NT Server 3.51, 4.0 can be configured as a DHCP server.
Give the printer a static address
Configure the DHCP server to so that the printer has a static address.
Note
When numerical DHCP server exists, turn an equal reservation into all DHCP
server. A Network Interface Board works by information from DHCP server
replied to in the first place.
Follow the steps below to provide the printer with a static IP address.
A
Start DHCP manager.
B
Select the scope that will be used, and on the [Scope] menu, click [Reserva-
tion].
C
Enter the IP address into [IP Address].
D
Enter the MAC address of the Network Interface Board into [Unique Identifi-
er].
Note
Do not use hyphens to separate the numbers.
If you don't know the MAC address, it can be found on the "configuration
page" printed by the printer.
E
Input a name and comment into the [Client Name] and [Client Comment] boxes.
Note
For additonal information about client names, please refer to P.87 "The
Others".
F
Click [Add].
An IP address is reserved.
G
Click [Close], to close dialog.
The Others
• When you click [Active Lease] on the [Scope] menu of DHCP manager, a list of
a client leases appears.When IP address reserved is not assigned to a Network
Interface Board, a client name of this dialog appears the name that was input
into with [Add Reserved Clients] dialog. When IP address reserved is assigned
to a Network Interface Board and comes to use it, an appearing client name
Please Be Careful
6
87