Command List - Ricoh AP204 Operator's Manual

The Network Interface Board is reset automatically when the settings are
changed.
When the Network Interface Board is reset, the active print job which has
already been sent tot the printer, will finish printing. However, jobs that
haven't been sent yet will be cancelled.

Command List

This is a list of commands that can be done via remote maintenance.
Note
Input "help", to see a list of commands that can be used.
msh> help
Input "help command_name", to display information about the syntax of that
command.
msh> help command_name
TCP/IP Address
Use the ipconfig command to configure TCP/IP (IP address, subnet mask,
broadcast address, default gateway address).
Reference
msh> ifconfig
Configuration
msh> ifconfig le0 parameter address
Parameter
(no parameter)
netmask
gateway
The following is an example for configuring an IP address of 192.168.15.16.
msh> ipconfig le0 192.168.15.16
The following is an example for configuring a subnet mask of 255.255.255.0.
msh> ipconfig le0 netmask 255.255.255.0
Note
This affects the configuration of the Network Board of the IP address that is
used.
To input an address using Hex (??), add "0x" to the first command.
Configuration Item
IP address
subnet mask
default gateway address
Remote Maintenance by Telnet (mshell)
6
67