Removing Misfed Paper - Ricoh AP204 Operator's Manual

Removing Misfed Paper

When a paper misfeed occurs, an error message appears on the panel display.
The procedure you should follow to remove the misfed paper depends on its
location which is indicated on the panel display.
Important
Toner printed on misfed paper is not fused and can make your hands or cloth-
ing dirty. Take care to avoid contact with the toner as you remove misfed pa-
per.
Check the following points if paper continues to misfeed.
• Make sure the paper in the tray matches the size for which the tray is set up.
• Make sure the number of sheets do not exceed the maximum capacity of
the tray.
• Make sure misfed paper is still not inside the printer when you resume
printing.
• Make sure paper is properly loaded in the paper tray.
• Make sure you are using only the appropriate type of paper.
If misfeeds persist, contact your sales or service representative.
Do not touch the photoconductor unit when removing misfed paper. If you
do, the photoconductor unit might be damaged.
To reset the printer after a misfeed, it is necessary to open and close any of
covers.
R CAUTION
• When accessing the inside of the machine, do not touch any sections
other than those specified in this manual. If you do, it might result in
receiving a burn or an injury.
R CAUTION
• The paper tray does not have a stopper. When pulling it out, be care-
ful not to pull it strongly. If you do, the tray might fall and cause a
personal injury.
Removing Misfed Paper
6
71