Ricoh AP204 Operator's Manual page 33

Installing Options
F
Insert the printer board into the
printer. Fasten both screws.
2
Important
Make sure that both screws are
used to secure the printer board.
Note
A coin can be used to fasten the
screws.
G
Loop the network interface cable.
The loop should be about 15 cm
(6") from the end of the cable.
H
Attach the ferrite core to loop.
14
I
Attach the network interface cable
to the network interface connector
of the printer as shown in the il-
lustration.
TPOP330E
J
Connect the other end of the net-
work interface cable to the net-
work.
K
Plug the printer's power cord back
into the printer and the wall out-
let. Turn on the printer's power
switch.
L
Print a configuration page to con-
firm that the network interface
board is properly installed.
Reference
=> P.101 "Printing the Configura-
tion Page"
Note
You can check if the network in-
terface board is installed prop-
erly by checking the "Network"
item of the "Status List" on the
TPOH390E
configuration page.
If the network interface board is
not properly installed, repeat the
above steps again. If you fail
again, contact your sales or ser-
vice representative.
After installing the network in-
terface properly, set up the
printer's network environment
using the operation panel. =>
P.23 "Configuring the Printer for the
Network with the Operation Panel"
TPOH440E