Ricoh AP204 Operator's Manual page 68

Paper Supported by This Printer
Adhesive Labels
Load adhesive labels into the tray with the print side up.
Remove any unused adhesive labels from the tray after you are finished print-
ing. Leaving them in the tray can cause them to curl.
The paper tray can hold up to 30 adhesive labels. Make sure that the stack of
paper is no higher than the LABEL upper limit mark (T) inside the tray.
Use adhesive labels which can be printed on the whole side.
Avoid using the adhesive labels on which glue is exposed.
If the print side is coated, the print quality might be reduced, as the toner
might fuse well.
When printing on adhesive labels, you should select the thick paper mode
with the printer driver.
OHP Transparencies
When printing on an OHP transparency that has a print side, load it face up in
the paper tray.
5
When printing on an OHP transparency that has tape on it, load it in the pa-
per tray so that the edge with tape is the trailing edge.
When printing on the OHP transparencies, you should select the OHP trans-
parency mode with the printer driver.
Remove any unused OHP transparencies from the tray after you are finished
printing. Leaving them in the tray can cause them to curl.
The paper tray can hold up to 50 OHP transparency sheets. Make sure that the
stack of paper is no higher than the OHP upper limit mark (T) inside the tray.
Be careful not to touch the print side of the OHP transparencies. Otherwise,
the print side may be dirty or damaged, resulting in poor print quality.
Paper not supported by this printer
Avoid using the following types of paper that are not supported by this printer.
• Paper whose weight is heavier or lighter than the limitation
• Bent, folded, or creased paper
• Curled or twisted paper
• Torn paper
• Wrinkled paper
• Damp paper
• Papers that are stuck together
• Paper that is dry enough to emit static electricity
49