Ricoh AP204 Operator's Manual page 103

Troubleshooting
E
Remove the left and right pins
from the new photoconductor
unit.
F
Remove the protective sheet from
the new photoconductor unit.
6
Note
The white powder on the photo-
conductor unit is to protect it af-
ter installation into the printer.
This white powder does not
have any adverse effect on the
interior of the printer.
84
G
Insert the new photoconductor
unit so that the protruding green
axles on both sides are aligned
with the tracks inside the green
lock levers. Lower it until the gears
mesh securely.
TPOH220E
Important
When inserting the photo-
conductor unit, be careful not to
damage the surface of it.
H
Return the green lock levers to
their original positions.
TPOH210E
Important
Do not return lock levers with
force. If you cannot lock them
easily, pull the photoconductor
unit from the printer. Then rein-
sert it again until the gears mesh
securely. After that, try returning
the levers to their original posi-
tions.
TPOH230E
TPOH590E