Ricoh AP204 Operator's Manual page 78

Message
B3: Error The printer setting is
wrong.
B5: Error An error has occurred in
the optional RICOH-
SCRIPT 2 kit.
B6: Error An error has occurred in
the optional parallel inter-
face board.
B7: Error. An error has occurred in
the optional network inter-
face board.
85: Error An error has occurred in
the printer's standard
memory.
86: Error You might not use the
correct interface cable.
You may be trying to print
with the wrong printer
driver.
91: Error An error has occurred in
the printer's standard
memory.
Description
Reset the printer using "Menu Reset" of
the "Maintenance" menu. => P.91 "Mak-
ing the Printer Settings with the Operation
Panel"
If this does not clear the error message,
contact your sales or service representa-
tive.
Remove the RICOH-SCRIPT 2 kit from
the printer and turn off and on the
printer's power switch. Then, try to
perform your printer job.
If the same message appears again,
contact your sales or service representa-
tive.
Remove and reinstall the optional paral-
lel interface board. If this does not clear
the error message, contact your sales or
service representative.
Remove the network interface board
from the printer and turn the printer's
power switch off and on. Try to print
again.
If the same message appears again,
contact your sales or service representa-
tive.
Turn off and on the printer's power
switch.
If the same message appears again,
contact your sales or service representa-
tive.
Make sure you are using the correct
printer driver.
Make sure you are using the correct
interface cable. => P.110 "Specifications"
Turn the printer's power switch off and
on.
If the same message appears again, con-
tact your sales or service representative.
Error & Status Messages
Comments
Note
If you remove the network interface
board, you cannot perform your
print job over the network. You can
send your print job to the printer
only via a parallel cable connection.
6
59