Ricoh AP204 Operator's Manual page 179

NetWare Configuration
C
Click [Property Sheet] and click [OK].
The Browse dialog of the Network Interface Board appears.
D
Click [IPX network board].
E
F
Select the name of the Network Interface Board which is to be configured
by clicking it, and click [Next >].
Note
3
If you don't know which Network Interface Board you are configuring,
print the Configuration Page using the printer's operation panel, and select
the MAC address that is on the page.
G
Confirm that the MAC and IPX addresses are correct, and click [Finish].
[NIB Setup Tool] window appears.
H
Click [Configure].
The property sheet appears.
I
Click the [NetWare] tab, and make the following settings.
A In the [Print Server Name] box, input the name of the print server.
B In the [File Server Name] box, input the name of the file server in which a
print server is to be created.
Clicking [Browse], you can select a file server among those listed in the
Browse dialog.
C In the [NDS Context] box, input the context in which the print server is to
be created.
Clicking [Browse], you can select a context among those listed in the
Browse dialog.
Note
Object names must be input from a lower level and divided by a period.
For example, if you want to create a file server into NETWORK under
DS, input "NETWORK. DS".
D In the [Print server Operation mode] group, click [As Print Server].
E Click [OK] to close the property sheet.
F After the message appears to confirm the reboot, click [Yes].
J
In the [NIB] menu, click [Exit] to exit the NIB Setup Tool.
K
From Windows, run NWadmin.
36