Ricoh AP204 Operator's Manual page 77

Troubleshooting
Message
Reset Fusing
Unit Correctly
Reset PCU
Correctly
Reset Tray
Correctly
Reset xxx
Toner Correctly
Waste Toner is
Full
A3: Error
6
A6: Error
AB: Error
B0: Error
B1: Error
58
Description
The fusing unit is not
installed in the printer.
The photoconductor unit is
not installed in the printer.
The paper tray is not in-
stalled correctly.
The indicated toner car-
tridge is not installed
correctly.
The waste toner bottle is
full, or the waste toner
bottle is not installed in the
printer.
There is too much data for
the I/O buffer to handle.
There is not enough printer
memory to print one or
more of the pages in the
print job.
The printer is unable to
process the data you are
trying to print.
An error has occurred in
the optional memory unit
(SIMM).
An error has occurred in
the standard parallel inter-
face.
Comments
Contact your sales or service represen-
tative.
Install the photoconductor unit. => P.82
"Replacing the Photoconductor Unit"
Install the paper tray correctly.
Install the indicated toner cartridge
correctly. => P.80 "Replacing the Toner
Cartridges"
Check if a waste toner bottle is installed
in the printer. If there is a bottle in-
stalled, replace the waste toner bottle.
=> P.86 "Replacing the Waste Toner Bottle"
Check if the interface cable is inserted
into the printer and your computer
securely.
Check if the interface cable is not dam-
aged or broken.
Increase the printer's I/O buffer.
=>P. 91 "Making Printer Setting with the
Operation Panel"
=> P.108 "Low Memory"
Install an optional memory unit (SIMM)
to increase printer memory capacity.
Reduce the amount of data being sent to
the printer.
Remove the memory unit from the
printer and turn off and on the printer's
power switch. Then, try to perform
your printer job.
Note
If you remove the memory unit, you
might not perform your print job
including the large complex data.
If the same message appears again,
contact your sales or service representa-
tive.
Contact your sale or service representa-
tive.