Ricoh AP204 Operator's Manual page 213

Appendix
Note
If you prohibit remote access using TCP/IP and then logout, you cannot use
remote access. If this was a mistake, you can use the printer operation panel
to allow access by TCP/IP.
When you prevent access via TCP/IP, you are also prevented from using lpr,
ftp and rsh.
Status of Printer
The following commands can be used to get information about the current status
of the printer.
msh> command
Command
status
info
prnlog [ID]
6
netstat
Note
More information on the print job is displayed when the ID number is added
after the prnlog command.
Reference
For more information on the meaning of the data returned with these com-
mands, refer toP.77 "Configuring the Network Interface Board".
Information about the Network Interface Board Configuration Settings
Use the show command to display the Network Interface Board configuration
settings.
msh> show [-p]
Note
Add "-p" to the show command to have the information displayed one screen
at a time.
Reference
For more information on the meaning of the data returned with this com-
mand, refer to
70
Information that is displayed
Status of printer.
Information about the print job.
Information about the paper tray, output tray, emulation
and program of printer.
Lists the last 10 print jobs.
Information about the network interface board.
P.77 "Configuring the Network Interface Board".