Cleaning and Adjusting the Printer
Cleaning the Charge Wire
The charge wire requires cleaning
when your printouts appear dirty.
R CAUTION
• When accessing the inside of
the machine, do not touch any
sections other than those speci-
fied in this manual. If you do, it
might result in receiving a burn
or an injury.
R CAUTION
• Do not open the front cover
when the paper tray is pulled out
halfway. If you do, it might cause
a personal injury.
Important
Do not touch the surface of the
photoconductor unit. If you do, the
photoconductor unit might be dam-
aged and the print quality might be
reduced.
Do not expose the photoconductor
unit to a light source greater than
800 luxes for more than two min-
utes. If you do, the photoconductor
unit might be damaged and the
print quality might be reduced.
Do not touch the photoconductor
unit on any surface. It you do, the
photoconductor unit might be dam-
aged and the print quality might be
reduced.
Cleaning and Adjusting the Printer
A
Press the printer's power switch to
turn off power.
B
Open the front cover by pulling
the front cover open lever and
open the top cover by pulling the
top cover open lever.
C
Release the brush locks (1 1 1 1 1 ) and re-
move the wire brush (2 2 2 2 2 ).
D
Stand up the green lock levers to a
vertical position.
TPOH191E
6
TPOH690E
TPOH560E
75