Ricoh AP204 Operator's Manual page 215

Appendix
Access Type
read
write
trap
no
Protocol configuration
You should use the following command to set the protocols to active or inac-
tive. If you set a protocol to inactive, you cannot use all the registered num-
bers for it.
msh> snmp {ip | ipx} {on | off}
• "On" means active and "Off" means inactive
If you want to change the protocol settings for each registered number,use the
following command. Make sure that the protocol set to inactive using the
above command, cannot set to be active using this command.
msh> snmp number active {ip | ipx} {on | off}
Access Configuration
6
You can configure an address of a host depending on the protocols used.
The Network Interface Board accepts requests only from hosts having ad-
dresses with access types of "read-only" or "read-write". Input "0" to have
the Network Interface Board accept requests from any host without requiring
a specific type of access.
The following example shows how set the protocol for an address.
msh> snmp number {ip | ipx} address
Note
When using the TCP/IP protocol, input ip followed by a space and then
the IP address.
When using the IPX/SPX protocol, input ipx followed by a space and then
the IPX address followed by a decimal and then the MAC address of the
Network Interface Board.
The following is an example of how to configure registration number 3 with
the IP address 192.168.15.16.
msh> snmp 3 ip 192.168.15.16
The following is an example of how to configure registration number 3 with
the IPX address 7390 A448, and the MAC address 00:00:74:62:5C:65.
msh> snmp 3 ipx 7390A448.000074625C65
Changing the Password
Use the passwd command to change the remote maintenance password.
Important
Be sure not to forget or lose the password.
72
Type of access which is permitted
Read only access is permitted.
Read and write access is permitted.
User is notified of trap messages.
All access is denied.