Ricoh AP204 Operator's Manual page 72

C
{U} {U} and {T} {U} {T} {T} to display "Cus- {T}
Use {U} {U} {T}
tom," and then press { { { { { Enter} } } } } .
This following message appears.
<Custom>
UT/# Width 140mm
D
Use {U} {U} and {T} {U} {U} {U} {T} to change the {T} {T} {T}
third (leftmost) digit of the paper
width.
<Custom>
UT/# Width 140mm
E
When the third digit is the value
you want, press { { { { { Enter} } } } } to move the
T T T T T pointer to the second digit.
<Custom>
UT/# Width 140mm
Note
You can press {Escape} to move
the pointer to the left.
F
{U} {T} {U} {T} to change the second {U} {T}
Use {U} {T} {U} {T}
(center) digit of the paper width.
<Custom>
UT/# Width 120mm
G
Repeat steps E and F to set the
value of the first (rightmost) digit
of the width.
H
While the pointer is located at the
first digit (rightmost) of the width,
press { { { { { Enter} } } } } to advance to the
length setting display.
<Custom>
UT/# Length216mm
I
Use the same procedure as that for
the width to set the three length dig-
its. Move the T T T T T pointer to the left
with { { { { { Escape} } } } } and to the right with
{ { { { { Enter} } } } } . Use {U} {U} {U}
{U} and {T} {U}
the digit where the pointer is lo-
cated.
J
T
K
T
T
T
T
{T} {T}
{T} to change {T}
While the T T T T T pointer is located at
the first (rightmost) digit of the
length, press { { { { { Enter} } } } } .
The "Paper Size" menu appears.
Press { { { { { On Line} } } } } .
The normal display screen appears.
Note
To change back from the "Cus-
tom" size setting to automatic
paper size detection, use {U} and
{T} in step C C C C C of the above pro-
cedure to scroll to "Auto Detect",
and then press {Enter}.
Loading Paper
5
53