Ricoh AP204 Operator's Manual page 118

3. Energy Saver
You can specify after how many minutes the printer should enter the Energy
Saver mode if no operation is performed. The Energy Saver mode reduces elec-
tric power consumption.
• Off
• 5 minutes
• 15 minutes
• 30 minutes
• 45 minutes
• 60 minutes
Important
After the printer enters the Energy Saver mode, it takes some time to warm
up again when print data is received.
4. Transfer
You can specify the data transfer speed of the parallel interface. If you are
having trouble with data transfers, try changing this setting to "Normal".
• Hi-speed
• Normal
Note
This setting is effective only for "Parallel 1".
5. Image Memory
This setting controls what the printer does when the printer memory is not
enough to print a certain page.
• On
• Off
"Off" causes the message shown below to be printed when there is not enough
memory to process.
Selecting "On" reduces the resolution of the image to reduce memory require-
ments.
6. Parallel 1
You can specify the parallel interface timing setting. Normally it is not neces-
sary to change this setting.
• ACK inside
• ACK outside
• STB down
Menu Settings
7
99