Installing The Printer Driver Using Plug And Play - Ricoh AP204 Operator's Manual

Installing the Printer Driver Using Plug and Play

Preparation
Check to make sure that the printer is connected properly to your computer,
and that computer power is turned off.
A
Turn on the printer.
B
Turn on your computer.
Continue with one of the procedures below in accordance with what appears
on your computer's screen.
Note
What happens after you turn on your computer depends on which version
of Windows 95/98 you are running and on your system setup.
When the [New Hardware Found] dialog appears
This dialog indicates that plug and play is working. Continue with the proce-
dure under "Plug and Play Installation 1" on page 32.
When the [Device Driver Wizard] appears
This indicates that plug and play is working. Continue with the procedure under
"Plug and Play Installation 2" on page 33.
When Widows 95/98 starts normally
This indicates that plug and play is not working. Continue with the procedure
under "Installing the Printer Driver Without Using Plug and Play" on page 34.
Windows 95/98 - Installing the IPDL-C Printer Driver
4
31