Ricoh AP204 Operator's Manual page 292

D
Use { { { { U U U U } } } } { { { { T T T T } } } } to display the menu you want to change, and then press { { { { En-
ter} } } } .
<RPS2 Menu>
1.Resolution
The current setting of the selected menu appears on the panel display.
<2.Resolution> j
*600 dpi
Note
An asterisk (*) is located to the left of the menu item's current setting.
E
Use { { { { U U U U } } } } { { { { T T T T } } } } to select the setting you want, and press { { { { Enter} } } } .
The setting you have selected is registered.
F
Repeat steps C C C C and D D D D to change the settings of other items.
G
Press { { { { On Line} } } } .
The settings are registered and the printer returns to the normal display
screen.
Reference
You can check the current setting by printing a configuration page.
"Printing the Configuration Page"
RPS2 Menu
Settings that you can specify are described below. Settings made with the printer
driver normally take priority, except when a printer driver setting is set to use
the printer's settings.
Color Mode
Use this to select either monochrome or color printing.
Resolution
Use this to set the resolution to 300dpi or 600dpi.
Color Set (Color Setting)
Use this to specify the correction method used for converting the RGB data to
CMYK data.
• Bright
Select this setting to generate without loss of pure black and perform
CMYK conversion with enhanced saturation.
• Super Bright
Making Printer Settings with the Operation Panel
j
l
l
4
P.55
51