Tm16 (16-Bit Timer) - Panasonic FP7 Series Command Reference Manual

3.18 TM16 (16-bit Timer)

3.18 TM16 (16-bit Timer)

■
Ladder diagram
■
List of operands
Operand Description
n Timer number (Available range: 0 to 4095 *For the default memory configuration)
S Timer setting value (Available range: U0 to U65535)
■
Devices that can be specified (indicated by ●)
Operan
d
W W
X Y
n
S ● ●
■
Outline of operation
● Unlike the TM instruction, the range available for the setting value [S] for this instruction is
U0 to U65535.
● The timer is the non-hold type that is reset when the power is turned off or the operation
mode is switched from RUN to PROG.
● When the execution condition is ON, the timer starts decrementing from the set time S.
When the elapsed value reaches U0, the timer contact Tn (n is the timer contact number)
turns ON.
● When the execution condition turns OFF during the subtraction operation, the elapsed value
is reset (cleared to zero).
● The OT instruction can also be written immediately after a timer coil.
● The timer set time is (timer unit) × (timer set value).
"TM16S" is specified within the range from 0.00000 to 0.65535 seconds, in units of 0.00001 seconds.
"TM16L" is specified within the range from 0.000 to 65.535 seconds, in units of 0.001 seconds.
"TM16R" is specified within the range from 0.00 to 655.35 seconds, in units of 0.01 seconds.
"TM16X" is specified within the range from 0.0 to 6553.5 seconds, in units of 0.1 seconds.
3-46
16-Bit device:
W W W S D L
R L S D T D
● ● ● ●
32-Bit
device:
TS TE
U W
WI IX
C C
M O
S E
●
Real St
Integer numbe rin
r g
D
K Ｕ H SF " "
F
●
●
WUME-FP7CPUPGR-12
Index
modifie
r
●
●