Panasonic FP7 Series Command Reference Manual page 370

Hide thumbs Also See for FP7 Series:

Table of Contents

7.9 ENCO (Encoding)

Example) [S]...DT10

DGT S , S1 , n , D , D1

Transfer [n] digits from the [S1]th digit of the area specified by [S], to the [D1] digit of the 16-bit

data specified by [D]. Transfer starts with the 0th digit, 1st digit, 2nd digit, and 3rd digit by every

four bits from the lower level.

Conversion-enabled bits are DT10 to DT11 (32 bits from DT10).

The bit numbers that are ON in these two-word area are stored in a decimal form from Bit 0 of

Precautions for programming

● If an unsigned constant U is specified for [S], it should be converted as Hex data.

Flag operations

[n]...H 0005

To be set in the case of out-of-range in indirect access (index modification).

To be set when the conversion-enabled bit length (nL) is not in the following range: 1 ≤ nL ≤

To be set (for consistency) when the sum of the result output starting bit number "nH" and

the conversion-enabled bit length "nL" is not in the following range: 1 ≤ nH + nL ≤ 16.

To be set when the data to be encoded is all "0".

Bit 8, counted from the lowest bit of DT10, is ON.

Store H8 in DT20.

WUME-FP7CPUPGR-12