Panasonic FP7 Series Command Reference Manual page 863

■
Available bit devices (●: Available)
Operand
X
S ●
n
D1
(Note 1)
●
D2
D3
(Note 1) When the receiver is FP7, only global devices can be specified. (A local device cannot be specified.)
■
Outline of operation
● Data can be transferred from the master unit to the partner unit between PLCs connected by
MEWNET-W or MEWNET-W2.
● When the SEND instruction is executed, the data is read from the device that starts with [S]
in the master unit and the data is stored in the address that starts with [D2] in the partner
unit.
■
Setting the amount of sent data [n]
Transfer method
Register transfer
Bit transfer
(Note 1) The transfer method varies according to the device type specified for operands [S] and [D2]. The
register transfer is used for 16-bit devices and the bit transfer is used for 1-bit devices.
16-bit device: WX, WY, WR, WL, DT, LD
1-bit device: X, Y, R, L, DT.n, LD.n
(Note 2) The amount of sent data is specified in words for the register transfer and in bits for the bit transfer.
■
Specification of partner unit station number [D1]
Communication Mode
W mode
W2 mode
■
Specification of destination address [D2]
Transfer method
Register transfer
WUME-FP7CPUPGR-12
16.1 SEND (When FP7 Multi-wire Link Unit Is Used)
Bit device
Y R L T C
● ● ●
● ● ●
Communication Mode
W mode
W2 mode
W mode
W2 mode
Devices specified for [S] and [D2]
Communication Mode
W mode
P E SR IN OT
Address range
0 to 65535
Specification of bit of
word device
DT.n LD.n
● ●
Amount of sent data n
1 to 55 words
1 to 1020 words
Fixed at 1 bit
Fixed at 1 bit
Transfer method
Register
transmission
Bit transmission
Setting range
1 to 32
1 to 64
Index
modifier
●
●
16-3