Panasonic FP7 Series Command Reference Manual page 849

DT0
DT1
DT2
DT3
DT4
DT5
DT6
DT7
DT8
DT9
DT10
DT11
Higher byte Lower byte
H 0
DT100
■
Program example 2 (pPMSET instruction)
● This program sets 12 words of communication parameters for COM1 port of CPU with built-
in SCU, which are stored in the area starting with Data Register DT0. The processing result
is stored in DT100.
● For the pPMSET instruction, when the execution condition arises, the parameter change
processing is performed only once.
■
Program example 3 (PMSET instruction, specification by PLC link parameter)
● This program sets 26 words of communication parameters for COM1 port of CPU with built-
in SCU, which are stored in the area starting with Data Register DT0. The processing result
is stored in DT100.
WUME-FP7CPUPGR-12
15.8 PMSET / pPMSET (Change of SCU Parameters)
U 0 Communication mode
Unit no. setting
U 1
U 5 Baud rate setting
Data length setting
U 1
U 1 Parity setting
U 0 Stop bit length setting
U 0 RS/CS valid or invalid
U 0 Send waiting time
U 0 Header STX
U 0 Terminator setting
Terminator judgment time
U 0
Modem initialization
U 0
Processing result ('0' for normal completion)
H 0
15-55