Panasonic FP7 Series Command Reference Manual page 984

17.18 HTTPcREQ (HTTP Client Transfer Request)
Transfer setting (Executes HTTPcSET
(3)
instruction)
■
Control relay
Name
Transfer request relay
Transfer active relay
Transfer retry active relay
Execution done relay
Execution result relay
Transfer direction relay
(Note 1)
Reserved for system
Transfer cancel request
(Note 2)
relay
Transfer disable relay
(Note 1) It is 0 (fixed) for logging and sending mails.
(Note 2) It is 0 (fixed) for logging and HTTPc.
(Note 3) The state of control relays can be read with ETSTAT instruction.
■
Done codes
Name
Execution done code
Transfer done code
(Note 1) The state of completion codes can be read with ETSTAT instruction.
When the instruction is executed under one of the following conditions, a transfer error occurs
and the corresponding error code is set in the execution done code.
Status
Destination server is not set.
Transfer setting is not set.
Registering a process request failed.
■
HTTP client preparation done (WX6 bit 8)
Name
HTTP client preparation
done (X68)
(Note 1) For details of Ethernet-related flags, refer to
17-96
Bit No. Description
0 0: No request, 1: Request
1 0: Stop, 1: During transfer
2 0: No retry, 1: During retry
3 0: During process, 1: Instruction execution complete
4 0: Normal 1: Failed
5 0: Send, 1: Receive
6 to 13 -
14 0: Not cancel, 1: Cancel
15 0: Transfer enabled, 1: Transfer disabled
Number of
Description
words
1 Execution done code
1 Response code of HTTP client
Code
1
2
4
Bit No. Description
0: HTTP client preparation incomplete, 1: HTTP client preparation
8
complete
Transfer process done (Completes the execution of
(6)
HTTPcREQ instruction)
Status
Transfer prohibition setting
Data decompression failed. (When
accessing data with PUT)
Data decompression failed. (When
accessing data with GET)
"19.10 Ethernet Function: IP
Code
5
8
9
Addresses".
WUME-FP7CPUPGR-12