Panasonic FP7 Series Command Reference Manual page 963

Transfer setting (Executes FTPcSET
(3)
instruction)
■
Control relay
Name
Transfer request relay
Transfer active relay
Retry active relay
Execution done relay
Execution result relay
Transfer direction relay
Reserved for system
Transfer cancel request
relay
Transfer disable relay
(Note 1) The state of control relays can be read with ETSTAT instruction.
■
Done codes
Name
Execution done code
Transfer done code
(Note 1) The state of completion codes can be read with ETSTAT instruction.
When the instruction is executed under one of the following conditions, a transfer error occurs
and the corresponding error code is set in the execution done code.
Status
Destination server is not set.
Transfer setting is not set.
Registering a process request failed.
■
FTP client preparation done (WX6 bit 5)
Name
FTP client preparation
done (X65)
(Note 1) For details of Ethernet-related flags, refer to
■
Flag operations
Name Description
SR7 To be set when the slot number [S1] specified with UNITSEL is not 100 (built-in ET-LAN).
SR8 To be set in the case of out-of-range in indirect access (index modification).
WUME-FP7CPUPGR-12
17.14 FTPcREQ (FTP Client Transfer Request)
Bit No. Description
0 0: No request, 1: Request
1 0: Stop, 1: During transfer
2 0: No retry, 1: During retry
3 0: During process, 1: Instruction execution complete
4 0: Normal 1: Failed
5 0: Send, 1: Receive
6 to 13 -
14 0: Not cancel, 1: Cancel
15 0: Transfer enabled, 1: Transfer disabled
Number of Description
words
1 Execution done code
1 Response code of FTP client
Code
1
2
4
Bit No. Description
0: FTP client preparation incomplete, 1: FTP client preparation
5
complete
Transfer process done (Completes the execution of
(6)
FTPcREQ instruction)
Status
Transfer prohibition setting
Data decompression failed. (When
accessing data with PUT)
Data decompression failed. (When
accessing data with GET)
"19.10 Ethernet Function: IP
Code
5
8
9
Addresses".
17-75