Panasonic FP7 Series Command Reference Manual page 9

3.35 SBL (Subroutine Label), RET (Subroutine Return)...........................3-109
3.36 CALL (Local Subroutine Call), FCALL (Output OFF Type Local
Subroutine Call) ....................................................................................3-111
3.37 ECALL (Subroutine Call (with PB No. Specification)) .......................3-113
3.38 EFCALL (Forced Output OFF Type Subroutine Call (with PB No.
Specification)) .......................................................................................3-115
3.39 INTPG (Unit Interruption Program Start), IRET (Unit Interruption
Program End)........................................................................................3-117
3.40 DI (CPU Interruption Disable), EI (CPU Interruption Enable) ...........3-122
3.41 IMASK (Unit Interruption Disable/Enable Setting) ............................3-123
3.42 ICLR (Unit Interruption Clear) ...........................................................3-125
3.43 STARTPG (PBn Execution Start), STOPPG (PBn Execution Stop) .3-127
3.44 GPB (Global PB Number Setting).....................................................3-130
3.45 COMOUT (Comment Out) / ENDCOM(Comment Out End) .............3-132
3.46 ST=, ST<>, ST>, ST>=, ST<, ST<= (Data Comparison: Start) ........3-133
3.47 AN=, AN<>, AN>, AN>=, AN<, AN<= (Data Comparison: AND) ......3-136
3.48 OR=, OR<>, OR>, OR>=, OR<, OR<= (Data Comparison (OR)) ....3-139
4 High-level Instructions(Data Comparison) .........................................4-1
4.1 CMP (Data Compare) .........................................................................4-2
4.2 WIN (Band Compare) .........................................................................4-6
4.3 BCMP (Block Comparison) .................................................................4-9
5 High-level Instructions (Data Transfer) ...............................................5-1
5.1 MV (Data Transfer) .............................................................................5-2
5.2 MV/ (Inversion and Transfer) ..............................................................5-4
5.3 MV2 (2 Data Transfer) ........................................................................5-6
5.4 MV3 (3 Data Transfer) ........................................................................5-8
5.5 BKMV (Block Transfer) .......................................................................5-10
5.6 COPY (Block Copy) ............................................................................5-13
5.7 BTM (Bit Block Transfer).....................................................................5-16
5.8 DGT (Digit Data Transfer) ...................................................................5-18
5.9 RST (Reset) ........................................................................................5-22
5.10 ZRST (Block Clear)...........................................................................5-24
5.11 BKEXT (16-bit Data Sign-extended Block Transfer) .........................5-26
5.12 BKMV16 (Block Transfer (32-bit Data to 16-bit Data))......................5-28
5.13 XCH (Data Exchange) ......................................................................5-30
5.14 SWAP (Exchange of High Bytes and Low Bytes) .............................5-32
5.15 BSWAP (High /Low Byte in n Block Exchange)................................5-34
5.16 LCWT (Specified PB Local Device Write).........................................5-36
5.17 LCRD (Specified PB Local Device Read) .........................................5-38
WUME-FP7CPUPGR-12 ix