Panasonic FP7 Series Command Reference Manual page 853

[S] value
0
1
2
3
4
5
■
Acquired data (communication parameters): When [S] = 0
Storage
Items
location
[D] Communication Mode
[D+1] Station number setting
[D+2] Baud rate setting
[D+3] Data length setting
[D+4] Parity setting
[D+5] Stop bit length setting
RS/CS enabled or
[D+6]
disabled
[D+7] Send waiting time
[D+8] Start code STX
[D+9] Terminator setting
Terminator judgement
[D+10]
time
[D+11] Modem initialization
[D+12] to
Reserved for system
[D+13]
[D+14] Link area block number
WUME-FP7CPUPGR-12
Type of acquired data
Communication parameter
Communication monitoring area information
PLC link status flag information
PLC link error frequency information
PLC link time interval information
PLC link settings parameter monitoring information
Range:
H0
U1
U2
U8
U9
U1 to
U999
U0 to U10
U0, U1
U0 to U2
U0, U1
U0, U1
(Note 1)
U0 to
10000
U0, U1
U0 to U3
U0 to
U10000
U0 to U2
H0
U0, U1
15.9 PMGET (Acquiring SCU Parameters)
Description
U0: MEWTOCOL-COM
U1: MEWTOCOL7-COM
U2: MODBUS-RTU
U8: General-purpose Communication
U9: PLC link
Station number U1 to U999
MEWTOCOL-COM: U1 to U99
MEWTOCOL7-COM: U1 to U999
MODBUS-RTU: U1 to U247
PLC link: U1 to U16 (Default: 0)
U0: 300, U1: 600, U2: 1200, U3: 2400, U4: 4800, U5: 9600,
U6: 19200, U7: 38400, U8: 57600, U9: 115200, U10:
230400 bps
U0: 7-bit length, U1: 8-bit length
U0: No parity, U1: Odd parity, U2: Even parity, U3: Parity
fixed to 0
U0: 1 bit, U1: 2 bits
U0: Disable, U1: Enable
U0: Immediate Effective time = Un x 0.01 ms (0 to 100 ms)
U0: Disable, U1: Enable
U0: CR, U1: CR+LF, U2: Time, U3: ETX
U0: 32 bits
Effective time = Un × 0.01 ms (Only enabled when the end
setting is "Time".)
U0: Not initialize
U1: Execute the first initialization only
U2: Re-execute initialization at the time of setting.
Reserved area for system
Block number of link relay/link register area
Number of stored data
26 word
7 word
8 word
9 word
8 word
192 word
(Note 2)
15-59