Ftpcreq (Ftp Client Transfer Request) - Panasonic FP7 Series Command Reference Manual

17.14 FTPcREQ (FTP Client Transfer Request)

■
Ladder diagram
(Note 1) The above figure shows the case that S1=U100 (built-in ET-LAN in the CPU unit) and S2=U1
(connection number 1) are specified by the UNITSEL instruction.
■
List of operands
Operand Description
S Device address where the transfer number (0 to 15) is stored, or a constant.
■
Devices that can be specified (indicated by ●)
Operan
d
W W
X Y
S ● ●
■
Outline of operation
● This instruction requests the transfer of the FTP client.
● Before executing this instruction, use the
instruction or the programming tool software "FPWIN GR7" to configure HTTP transfer
settings.
■
Operand [S] setting
Setting item Settings
Transfer
S
number
■
Processing
● The transfer request relay of the transfer number that is specified by [S] is turned ON.
● This instruction can be executed when the FTP client preparation done flag (X65) is ON. As
an execution condition of the instruction, insert a program that checks the status of the flag
(X65). An operation error occurs if this instruction is executed when the flag (X65) is OFF.
WUME-FP7CPUPGR-12
17.14 FTPcREQ (FTP Client Transfer Request)
16-Bit device:
W W W S D L
R L S D T D
● ● ● ●
Specify the device address storing a transfer number or a
constant.
32-Bit
device:
TS TE
U W
WI IX
C C
M O
S E
"17.12 FTPcSET (FTP Client Transfer Setting)"
Real St
Integer numbe rin
r g
D
K H SF " "
Ｕ
F
● ●
Setting
range
Index
modifie
r
●
0 to 15
17-73