SRX5800 Services Gateway Craft Interface Power Supply LEDs
Related
Documentation
SRX5800 Services Gateway Craft Interface Card OK/Fail LEDs
Related
Documentation
Copyright © 2015, Juniper Networks, Inc.
Each power supply has two LEDs on the craft interface that indicate its status. The LEDs,
labeled
through
, are located near the middle of the craft interface next to the
0
3
label.
Table 7 on page 27
describes the functions of the power supply LEDs on the craft
interface.
Table 7: Power Supply LEDs on the Craft Interface
Label
Color
Green
PEM
Red
SRX5800 Services Gateway Craft Interface Overview on page 24
SRX5800 Services Gateway Craft Interface Host Subsystem LEDs on page 26
SRX5800 Services Gateway Craft Interface Card OK/Fail LEDs on page 27
Each slot in the card cage has a pair of LEDs on the craft interface that indicates the
status of the card installed in it. The card LEDs are located along the bottom edge of the
craft interface and are labeled as follows:
through
on the left
0
5
and
for the two center slots reserved for SCBs
0
1
and
through
on the right
2/6
7
11
Table 8 on page 27
describes the functions of the
Table 8: Card OK/Fail LEDs
Label
Color
OK
Green
Red
FAIL
SRX5800 Services Gateway Craft Interface Overview on page 24
SRX5800 Services Gateway Craft Interface Power Supply LEDs on page 27
State
Description
On steadily
Power supply is functioning normally.
On steadily
Power supply has failed or power input
has failed.
OK
State
Description
On steadily
The card is functioning normally.
Blinking
The card is transitioning online or offline.
Off
The card is not online.
On steadily
The card has failed.
Chapter 3: Chassis Description
and
LEDs.
Fail
PEM
27