Powering Up The Server - Avaya S8500 Replacing

Replacing the cover and cabling
To replace the cover and cabling on the media server:
1. Replace the cover onto the server.
2. Slide the cover forward so the cover's tabs slide into place under the top slots of the front
panel.
3. Finger-tighten the thumb screws on the back of the server.
4. Release the retaining tabs on the rails and slide the S8500 Media Server back into place on
the data rack.
5. Locate the marked cable that you removed from the old NIC and plug it into the Ethernet 2
port, which is labeled "ACT/LINK A" on the small faceplate of the new NIC.
6. Connect all external cables.

Powering up the server

To power up the media server:
1. Plug the power cord into the power receptacle on back of the server.
2. Press the Power button located on the front right-hand side.
3. Log in to the server after the startup to ensure that the installation is complete.
Checking LED activity on the dual network interface card
When the media server is back in service, check the LEDs on each port of the dual NIC
(Figure 6: S8500 rear panel dual NIC LEDs on page 10).
555-245-760 Issue 3 January 2005 9