Chapter 7
Connecting the JCS 1200 Platform
Before you Begin Connecting the JCS 1200 Platform
This chapter discusses the following procedures:
Before you Begin Connecting the JCS 1200 Platform on page 59
Tools and Parts Required for Connecting the JCS 1200 Platform on page 60
Supplying Power to the JCS 1200 Platform on page 60
Connecting the JCS 1200 Management Module to the Network on page 68
Establishing Your JCS 1200 Management Module Connection on page 70
Connecting a Console to the JCS 1200 Routing Engines on page 72
Powering On a JCS 1200 Routing Engine on page 73
Powering Off a JCS 1200 Routing Engine on page 74
Connecting the JCS 1200 Platform to a T-series Routing Platform on page 74
Verifying that the JCS 1200 Platform is Powered On Correctly on page 79
Before connecting the T-series routing platform to the JCS 1200 platform, ensure
that the bootROM version for all FPCs is ROM Monitor Version 6.4 or later. If an FPC
bootROM version is earlier than Version 6.4, the FPC will not come online. To upgrade
the firmware, you must contact your Juniper Networks customer support
representative.
To determine if you need to upgrade the FPC firmware, display the version of the
firmware on all FPCs by issuing the show chassis firmware command:
user@host> show chassis firmware
Part
FPC 0
FPC 1
FPC 2
FPC 4
FPC 5
FPC 6
Type
Version
ROM
Juniper ROM Monitor Version 7.5b4
O/S
Version 9.1-20080222.0 by builder on 2008-0
ROM
Juniper ROM Monitor Version 6.4b18
O/S
Version 9.1-20080222.0 by builder on 2008-0
ROM
Juniper ROM Monitor Version 7.5b4
O/S
Version 9.1-20080222.0 by builder on 2008-0
ROM
Juniper ROM Monitor Version 6.4b18
O/S
Version 9.1-20080222.0 by builder on 2008-0
ROM
Juniper ROM Monitor Version 6.4b20
O/S
Version 9.1-20080222.0 by builder on 2008-0
ROM
Juniper ROM Monitor Version 7.5b4
O/S
Version 9.1-20080222.0 by builder on 2008-0
Before you Begin Connecting the JCS 1200 Platform
59