Figure 79: Removing And Installing A Jcs 1200 Power Module - Juniper JCS 1200 Hardware Manual

Installing a JCS 1200 Power Module
Figure 79 on page 139 shows how to remove and install a power module.

Figure 79: Removing and Installing a JCS 1200 Power Module

To install a power module (see Figure 79 on page 139):
1.
2.
3.
4.
Related Topics
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and
connect the strap to one of the ESD points on the chassis.
Remove the power module filler, if one is installed.
Make sure that the handle on the power module is in the open position.
Orient the new power module to the selected power module bay:
For the upper power module bays, the rear connector on the power module
must be facing down.
For the lower power module bays, the rear connector on the power module
must be facing up.
Preventing Electrostatic Discharge Damage to the JCS 1200 Platform on page 154
JCS 1200 Power Module Description on page 22
JCS 1200 Power Module LEDs on page 23
Locating the JCS 1200 Power Module Serial Number on page 202
Chapter 10: Replacing Components in a JCS 1200 Platform
Installing a JCS 1200 Power Module
139