Figure 46: Removing The Air Filter Assembly - Juniper JCS 1200 Hardware Manual

Juniper Control System (JCS) 1200 Platform Hardware Guide
4.

Figure 46: Removing the Air Filter Assembly

5.
Installing the JCS 1200 Bezel Filter
To install a bezel filter:
1.
2.
108
Installing the JCS 1200 Bezel Filter
Remove the air filter assembly from the filter frame by pulling out and rotating
the air filter assembly locks until they no longer engage the air filter assembly.
Remove the air filter assembly; then remove the old filter from the filter frame
and dispose of it.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and
connect the strap to one of the ESD points on the chassis.
Lay the bezel on a flat work surface and orient it so that the bottom of the bezel
is closest to you and the light path holes are to the right. The large rectangles in
the filter frame should be closest to you.