Figure 8: Jcs 1200 Management Module Leds And Controls - Juniper JCS 1200 Hardware Manual

Figure 8: JCS 1200 Management Module LEDs and Controls

The management module consists of the following components:
Serial connector—Use this connection to configure and manage the JCS 1200
components over a serial line through the management module CLI. This
connector provides local access to the CLI and any Routing Engine. For example,
you can connect a notebook computer to the serial connector and a terminal
emulator program to configure the IP addresses, user accounts, and other
management settings through the CLI user interface. See the JUNOS Protected
System Domain Configuration Guide for more information.
Video connector—The video connector is not supported.
Console (Ethernet) connector—Use this connector for a remote Ethernet
connection to a network management station on the network.
Two USB ports for mouse and keyboard—The USB ports are not supported.
Reset button—When you press this button, the blowers operate at full speed
while the management module is initializing.
The reset button provides the following functions:
Press and release the reset button to restart the management module.
Press and hold the reset button for 8 seconds to restore the management
module to factory default settings.
LEDs—There are five LEDs on the management module that provide status
information about the management module and remote management connection.
Table 10 on page 18 describes the functions of these LEDs (see
Figure 8 on page 17).
Chapter 2: Hardware Component Overview
JCS 1200 Management Module Connectors and LEDs
17