Juniper JCS 1200 Hardware Manual page 240

Juniper Control System (JCS) 1200 Platform Hardware Guide
Tools and Parts Required to Remove Components from the JCS 1200 Platform
To remove components from the platform or the platform from a rack, you need
the following tools and parts:
Related Topics
Packing the JCS 1200 Platform for Shipment
To pack the platform for shipment, follow this procedure:
1.
2.
3.
4.
5.
208
Tools and Parts Required to Remove Components from the JCS 1200 Platform
Locating the JCS 1200 Routing Engine Serial Number on page 203
Locating the JCS 1200 Switch Module Serial Number on page 205
2.5-mm flat-blade (–) screwdriver, for detaching alarm relay terminal block
10-mm. hexagonal-head external drive socket wrench, or nut driver
3/8-in. nut driver
7/16-in. nut driver
Blank panels to cover empty slots
Electrostatic bag or antistatic mat, for each component
Electrostatic discharge (ESD) grounding wrist strap
Flat-blade (–) screwdriver
Mechanical lift, if available
Phillips (+) screwdrivers, numbers 1 and 2
Rubber safety cap for fiber-optic PICs or PIC cable
Wire cutters
Contacting Customer Support on page 206
JCS 1200 Return Procedure on page 207
Packing the JCS 1200 Platform for Shipment on page 208
Guidelines for Packing JCS 1200 Platform Components for Shipment on page 209
Retrieve the shipping crate and packing materials in which the platform was
originally shipped. If you do not have these materials, contact your Juniper
Networks representative about approved packaging materials.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and
connect the strap to one of the ESD points on the chassis.
Shut down power to the JCS 1200 platform by pressing the power switch for all
power supplies to the off (
switch is located on the power supply faceplate.
Disconnect power from the JCS 1200 platform.
Remove the cables that connect to all external devices. See the removal procedure
for each component.
) position. On both AC and DC power supplies, the
O