Juniper JCS 1200 Hardware Manual page 126

Juniper Control System (JCS) 1200 Platform Hardware Guide
JCS 1200 Hardware Component Installation Checklist
Before you can use the JCS 1200 platform, you must install and configure the required
components in the JCS 1200 platform. If you have not already done so, perform the
activities on the following checklist:
1.
2.
3.
4.
5.
NOTE: Make sure that the JCS 1200 platform has adequate power to support all of
the installed components. The JCS 1200 platform must contain either two or four
power modules. See "JCS 1200 Platform Power Overview" on page 61 for more
information.
6.
7.
8.
9.
10.
11.
12.
Related Topics
94
JCS 1200 Hardware Component Installation Checklist
Set up the rack or cabinet in which you will install the JCS 1200 platform. See
"JCS 1200 Platform Rack-Mounting Hardware" on page 43.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and
connect the strap to one of the ESD points on the chassis.
Remove any modules that come installed in the JCS 1200 platform to reduce the
weight of the unit.
Install the JCS 1200 platform into the rack. See "Installing the JCS 1200 Platform
Using a Lift" on page 51.
Reinstall the removed modules in the JCS 1200 platform.
Install the required JCS 1200 platform components.
Supply power to the JCS 1200 platform. See "Connecting the JCS 1200 AC
Platform to AC Power" on page 62 or "Connecting the JCS 1200 DC Platform to
DC Power" on page 63 for more information.
Make sure that the latest level of firmware is installed on all of the JCS 1200
components. See
http://www.juniper.net/support/
Configure the management module in the JCS 1200 platform. For information
and instructions, see the JUNOS Protected System Domain Configuration Guide.
Determine the JCS 1200 platform configuration settings, such as the IP address,
network address, and wake-on-LAN settings. For instructions for configuring an
IP address, see the JUNOS Protected System Domain Configuration Guide.
Configure the switch modules in the JCS 1200 platform. For configuration
information, see the JUNOS Protected System Domain Configuration Guide.
Configure the Routing Engines. For information and instructions, see the JUNOS
Protected System Domain Configuration Guide.
JCS 1200 Hardware Component Installation Guidelines on page 95
JCS 1200 Platform System Reliability Guidelines on page 95
for additional information.