Juniper JCS 1200 Hardware Manual page 92

Juniper Control System (JCS) 1200 Platform Hardware Guide
FPC 7
SPMB 0
SPMB 1
CAUTION: By default, SNMP is enabled on the management module. Do not disable
SNMP. If you disable SNMP, you might not be able to access the management module.
Related Topics
Tools and Parts Required for Connecting the JCS 1200 Platform
To connect the JCS 1200 platform to T-series routing platforms, power, and
management devices and to power on the platform, you need the following tools
and parts:
CAUTION: Do not substitute a nonmetric nut driver or wrench. A tool that does not
fit the nuts exactly can damage them. If a 10-mm. tool is not available, use pliers or
an adjustable wrench.
Related Topics
Supplying Power to the JCS 1200 Platform
Topics include:
60
Tools and Parts Required for Connecting the JCS 1200 Platform
ROM
O/S
ROM
O/S
ROM
O/S
Connecting the JCS 1200 Platform to a T-series Routing Platform on page 74
2.5-mm Phillips (+) screwdriver
7/16-in. hexagonal-head external drive socket wrench, or nut driver, with a torque
range between 23 lb-in. (2.6 Nm) and 25 lb-in. (2.8 Nm), for tightening nuts to
terminal studs on each power supply on a DC-powered router.
Wire cutters
Pliers
Electrostatic discharge (ESD) grounding wrist strap
JCS 1200 Platform Power Overview on page 61
Connecting the JCS 1200 Management Module to the Network on page 68
Establishing Your JCS 1200 Management Module Connection on page 70
Connecting a Console to the JCS 1200 Routing Engines on page 72
Connecting the JCS 1200 Platform to a T-series Routing Platform on page 74
JCS 1200 Platform Power Overview on page 61
Connecting the JCS 1200 AC Platform to AC Power on page 62
Juniper ROM Monitor Version 6.4b20
Version 9.1-20080222.0 by builder on 2008-0
Juniper ROM Monitor Version 6.4b18
Version 9.1-20080222.0 by builder on 2008-0
Juniper ROM Monitor Version 6.4b18
Version 9.1-20080222.0 by builder on 2008-0