Figure 49: Removing And Installing The Jcs 1200 Cable Management - Juniper JCS 1200 Hardware Manual

Figure 49: Removing and Installing the JCS 1200 Cable Management Trays
The cable management trays can be removed with or without the JCS 1200 bezel.
If you are removing the JCS 1200 bezel, see "Removing a JCS 1200 Bezel" on page
97 more information.
To remove the cable management trays that are installed without the JCS 1200 bezel
(see Figure 49 on page 111):
1.
2.
3.
4.
Installing the JCS 1200 Cable Management Trays Without a Bezel
Figure 50 on page 112 shows how to remove and install the cable management trays.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and
connect the strap to one of the ESD points on the chassis.
Hold the cable management tray with one hand and use a Phillips-head
screwdriver to loosen the captured thumb screws that attach the cable
management tray to the JCS 1200 platform.
Pull the cable management tray away from the JCS 1200 platform.
Repeat these steps for the other cable management tray.
Installing the JCS 1200 Cable Management Trays Without a Bezel
Chapter 10: Replacing Components in a JCS 1200 Platform
111