Juniper Control System (JCS) 1200 Platform Hardware Guide
To install a media tray (see Figure 66 on page 129):
1.
2.
Figure 67: Positioning the Release Lever and Button on the JCS 1200 Media Tray
3.
4.
Related Topics
Replacing a JCS 1200 Midplane
NOTE: The midplane is not a field-replaceable unit (FRU). You cannot order a midplane
separately. If the midplane requires replacement, you must replace the entire chassis.
For instructions on replacing the chassis, see "Replacing a JCS 1200
Chassis" on page 113.
Related Topics
130
Replacing a JCS 1200 Midplane
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and
connect the strap to one of the ESD points on the chassis.
Make sure that the media tray release lever is in the open position and the
compact flash release buttons are pushed into the in position.
Slide the media tray into position until it stops and locks into place.
Rotate the media tray release lever to the closed position.
Preventing Electrostatic Discharge Damage to the JCS 1200 Platform on page 154
JCS 1200 Media Tray Description on page 18
JCS 1200 Media Tray Connectors and LEDs on page 19
Locating the JCS 1200 Media Tray Serial Number on page 200
Replacing a JCS 1200 Chassis on page 113
Locating the JCS 1200 Chassis Serial Number on page 196
Contacting Customer Support on page 206