Connecting A Console To The Jcs 1200 Routing Engines; Figure 31: Jcs 1200 Serial Port Breakout Cable - Juniper JCS 1200 Hardware Manual

Juniper Control System (JCS) 1200 Platform Hardware Guide
2.
3.
After you connect to the management module for the first time, perform initial
configuration of the JCS 1200 platform. See the JUNOS Protected System Domain
Configuration Guide for CLI configuration instructions.
Related Topics

Connecting a Console to the JCS 1200 Routing Engines

To access the Routing Engines from a console, you must use the serial port breakout
cable provided with the chassis to connect the JCS 1200 platform. The breakout cable
provides a direct serial interface to each Routing Engine in the JCS 1200 platform
and contains 14 RJ-45 serial cable connectors (see Figure 31 on page 72).

Figure 31: JCS 1200 Serial Port Breakout Cable

NOTE: Only 12 of the 14 RJ-45 serial cable connectors are used to connect the console
to the Routing Engines. Connectors 13 and 14 are reserved for future use.
To connect the console:
1.
2.
3.
72
Connecting a Console to the JCS 1200 Routing Engines
Stop bits—1
Open a terminal emulator window and establish a connection to the management
module serial port.
Enter the default user name, USERID, and the default password, PASSW0RD
(note the number zero, not the letter O, in PASSW0RD), to start the remote
session.
Tools and Parts Required for Connecting the JCS 1200 Platform on page 60
Connecting the JCS 1200 Management Module to the Network on page 68
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and
connect the strap to one of the ESD points on the chassis.
Connect the serial connector on the cable to the serial port connector on the
alarm panel module of the JCS 1200 platform.
Connect the each of the RJ-45 connectors on the cable to your console.