Juniper JCS 1200 Hardware Manual page 187

Related Topics
Fire Safety Requirements for the JCS 1200 Platform
In the event of a fire emergency involving routing platforms and other network
equipment, the safety of people is the primary concern. Establish procedures for
protecting people in the event of a fire emergency, provide safety training, and
properly provision fire-control equipment and fire extinguishers.
In addition, establish procedures to protect your equipment in the event of a fire
emergency. Juniper Networks products should be installed in an environment suitable
for electronic equipment. We recommend that fire suppression equipment be available
in the event of a fire in the vicinity of the equipment, and that all local fire, safety,
and electrical codes and ordinances be observed when installing and operating your
equipment.
Related Topics
JCS 1200 Installation Safety Guidelines and Warnings
Observe the following guidelines and warnings before and during platform installation:
JCS 1200 Chassis Lifting Guidelines
The weight of a fully configured chassis is about 350 lb (158.8 kg). Observe the
following guidelines for lifting and moving the platform:
Related Topics
Definition of Safety Warning Levels on page 149
Definition of Safety Warning Levels on page 149
JCS 1200 Chassis Lifting Guidelines on page 155
Installation Instructions Power Warning for the JCS 1200 Platform on page 156
Rack-Mounting Requirements and Warnings for the JCS 1200 Platform on page 156
Ramp Warning for the JCS 1200 Platform on page 160
Before moving the platform, read the guidelines in "Overview of Preparing the
Site for JCS 1200 Platform Installation" on page 33 to verify that the intended
site meets the specified power, environmental, and clearance requirements.
Do not attempt to lift a fully configured platform by yourself. Using a mechanical
lift to maneuver the platform into a rack is recommended. If a lift cannot be
used, a minimum of four people must lift the platform, and you must remove
components from the chassis before lifting.
Before lifting or moving the platform, disconnect all external cables.
As when lifting any heavy object, lift most of the weight with your legs rather
than your back. Keep your knees bent and your back relatively straight and avoid
twisting your body as you lift. Balance the load evenly and be sure that your
footing is solid.
Overview of Preparing the Site for JCS 1200 Platform Installation on page 33
Definition of Safety Warning Levels on page 149
Appendix A: Safety and Regulatory Compliance Information
Fire Safety Requirements for the JCS 1200 Platform
155